Kiesol

Product specifications

Appearance/colourClear to yellowish

Density (20°C)Approx. 1.15 g/cm³

pH valueApprox. 11

Strengthening≤ 5 N/mm²

Water repellencyw < 0.5 kg/(m²*h^0.5)

Water vapour permeability> 90%

The stated values represent typical product characteristics and are not to be construed as binding product specifications.

‍

Preparation

Substrate requirements

• Subsequent horizontal waterproofing of masonry
• Drilling channel must be free of drill dust.
• Priming for protection against the effect of water from behind
• The substrate must be clean and free of oil, grease and release agents.
• Surface improvement
• The substrate must be clean and free of oil, grease and release agents.

Preparations

• For injection in a low-pressure procedure, the wall surface must be plugged with Kiesol and waterproofing slurry to at least 30 cm above and below the row of boreholes.

• Subsequent horizontal waterproofing of masonry
• Production of boreholes:
  Single row, diameter 12 - 30 mm, spacing 10 - 12.5 cm, angle of inclination approx. 45°, borehole depth up to approx. 5 cm from end of wall.
• For walls > 0.6 m thick, it is recommended to make the series of drill holes on both sides.
• Pre-inject BSP 3 or BSP 6 (borehole suspension) into hollow masonry.
• Wait 7 days before carrying out further work.
• Re-pierce filled boreholes.
• For injection under pressure, plug the masonry surface with Kiesol and waterproofing slurry to a width of 50 cm in the region of the series of boreholes.

‍